Download and install the following mandatory performance patch on your Oracle Solaris host:. You will be unable to register the storage device using the CAM software until you install this patch.
If you are unable to access this web site, contact your Oracle Account Representative for assistance. If you are experiencing persistent log messages such as command slot is full , and other problems associated with known issue Known Issues , download the appropriate patch, listed in the following section, Oracle Solaris Performance Patch. To Download and Install the Windows Driver. Click to select and download the specific Windows driver that is supported by the Windows release on your hardware platform.
Click to select and download the corresponding Readme file for the Windows driver, and follow the instructions in the Readme file to complete the driver installation. To Download and Update the Windows Firmware. Under Utilities, click Windows to download the Windows utility program, lsiutil , and to download the corresponding Readme file.
Under Firmware, click to download the firmware zip file and the corresponding Readme file. Reboot the server a second time. The card is recognized after the second reboot. FMod support clips may break if pressed too far during FMod removal. These messages occur due to a hardware bug in the LSI SAS controller that may incorrectly detect underrun conditions and report them to the driver.
Overall data integrity is not compromised, but a performance impact may be observed due to the messages logged and retries required. If there is a significant unexpected drop in card performance, the supercap module on the ESM should be checked. On occasion, the system BIOS may not give the card firmware enough time to load. When this situation occurs, the card cannot be seen by host server. Repeated power cycling with minimum traffic causes FMod to zombie. Do not run continuous power cycle tests with minimum traffic to the FMod.
Because the pre-existing state of a FMod is unknown, it could have been power cycled previously, the number of power cycles cannot be specified. All rights reserved. This software and related documentation are provided under a license agreement containing restrictions on use and disclosure and are protected by intellectual property laws.
Except as expressly permitted in your license agreement or allowed by law, you may not use, copy, reproduce, translate, broadcast, modify, license, transmit, distribute, exhibit, perform, publish, or display any part, in any form, or by any means.
Reverse engineering, disassembly, or decompilation of this software, unless required by law for interoperability, is prohibited. The information contained herein is subject to change without notice and is not warranted to be error-free. If you find any errors, please report them to us in writing. If this is software or related software documentation that is delivered to the U. Government or anyone licensing it on behalf of the U.
Government, the following notice is applicable:. Government end users are "commercial computer software" pursuant to the applicable Federal Acquisition Regulation and agency-specific supplemental regulations.
No other rights are granted to the U. This software or hardware is developed for general use in a variety of information management applications. It is not developed or intended for use in any inherently dangerous applications, including applications that may create a risk of personal injury. If you use this software or hardware in dangerous applications, then you shall be responsible to take all appropriate fail-safe, backup, redundancy, and other measures to ensure its safe use.
Oracle Corporation and its affiliates disclaim any liability for any damages caused by use of this software or hardware in dangerous applications. Included with software. MPT 3. Linux RHEL 5, version 5. MPT 4. Host Out. SIM Link Out. Multipath-capable ports include SAS mpt[7D] controller ports. Prompts you to reboot. During reboot, vfstab and the dump configuration update to reflect the device-name changes.
Specifying -D mpt limits the enabling operation to ports attached using the specified driver. During reboot, vfstab and the dump configuration update to reflect the device name changes. Specifying -D mpt limits the disabling operation to ports attached using the specified driver.
Note - The system administrator is responsible for modifying application configuration for example, backup software, DBMS, and so forth to reflect updated device names. Note - Multipathing is not supported on all controllers.
After enabling multipathing, only supported controllers are placed under multipathing control. Non-supported controllers remain unchanged. To Enable Multipathing in Windows Fail Over Only. Round Robin.
0コメント